Land Pride 945551+, Operator'S Manual

Page: 47 / 56

43
Section 5: Maintenance & Lubrication
9/6/17 RC2512 Series 2 S/N Rotary Cutters 330-725M
Table of Contents
Constant Velocity Main Driveline Joints
Type of Lubrication: Multi-purpose Grease
For instructions on how to access grease zerks shown
in Figure 5-9, see
“Accessing CV Driveline Joints” on
page 44.
•
The constant velocity joint should be greased in a
straight position forcing grease through the passages
and into the cavity. After lubrication, grease should
be visible around the ball joints.
•
Grease fittings located on the u-joints should be
lubricated every 8 hours of operation.
IMPORTANT: To extend the life of the constant
velocity joint, extensive lubrication must be
performed every 8 hours of operation.
CV Main Driveline Profile Tubes
CV = Constant Velocity
Type of Lubrication: Multi-purpose Grease
Quantity = Coat Generously
IMPORTANT: To extend the life of the constant
velocity joint, extensive lubrication must be
performed every 8 hours of operation.
Figure 5-9
30636
8-10 pumps
Zerk Located through slot in tube
30636
2-3 pumps
4-6 pumps
4-5 pumps
2-3 pumps
8
Hrs
8
Hrs