23
Section 2: Adjustments
9/6/17
RC2512 Series 2 S/N Rotary Cutters 330-725M
7.
Be sure left and right leveling rods have equal
amount of tension and then re-tighten jam nuts (#3)
against adjusting nuts (#4).
Wing Deck Leveling
Refer to Figure 2-4:
Each wing section will need adjusting if top surface of
wing is not level with top surface of center deck when
wings are unfolded.
1.
With tractor hydraulics, lower wings down. Refer to
on page 28 for instructions on how to
lower wings.
2.
Pull cutter straight forward six to ten feet to allow
outer wing wheels to properly align themselves.
3.
Check wing tops to see if they are level with the top of
the center deck. If the outer edge of either wing top is
higher or lower than the center deck, then level wing
as follows:
a.
If outer wing edge is too high
, loosen nut (#1)
and rotate turnbuckle (#2) counterclockwise to
lower outer wing edge until wing is level. Tighten
nut (#1) against turnbuckle (#2) when level.
b.
If outer wing edge is too low
, loosen nut (#1)
and rotate turnbuckle (#2) clockwise to raise outer
wing edge until wing is level. Tighten
nut (#1) against turnbuckle (#2) when level.
Wing Deck Leveling (Right Wing & Center Deck Shown)
Figure 2-4
37532
Clockwise Rotation Shown
Center Deck Leveling
Figure 2-3
37531
LH Leveling Rod
RH Leveling Rod
Clockwise Rotation
Clockwise Rotation
