LANCOM OAP
-
54 Wireless and LANCOM OAP
-
310agn Wireless
Chapter 2: Installation
27
EN
Message
Gives general information about the device.
The power LED flashes red when a charge limit is reached.
2.4
The device connectors
The connections and switches of the LANCOM OAP-54 Wireless and LANCOM
OAP-310agn Wireless are located on the top and bottom side.
On the top are the two antenna connectors. The bottom side accommodates
the LAN and WAN connectors, the reset button and an additional antenna
connector.
Flashing Message-LED but no connection?
There's no need to worry if the Message-LED blinks red and you
con no longer connect to the WAN. This simply indicates that a
preset time or connect-charge limit has been reached.
There are three methods available for unlocking:
Reset connect charge protection.
Increase the limit that has been reached.
Completely deactivate the lock that has been triggered (set
limit to '0').
If a time or connect charge limit has been reached, you will be notified in LANmonitor. To
reset the connect charge protection, select
Reset Charge and Time Limits
in the context
menu (right mouse click). You can configure the connect charge settings in LANconfig under
Management
Costs
(you will only be able to access this configuration if 'Complete con-
figuration display' is selected under
View
Options…
).
You will find the connect charge protection reset in WEBconfig and all parameters under:
LCOS Menu Tree
Setup
Charges-module
Signal for reached time or
charge limit
off
Device ready for use
red
flashing (slow)
Time or connect-charge reached
red
flashing (fast)
Device insecure: configuration password not assigned
red
flickering
WLAN module defected
