Lancom DSL/I-1611, Manual

Page: 30 / 66

Basic configuration
|
|
LANCOM Office
|
30
EN
• You have not yet used IP addresses in your network but would like to
do so now. You would like to specify the IP address for your router,
selecting it from the address range reserved for private use,
e.g.'10.0.0.1' with the netmask '255.255.255.0'. At the same time you
will set the address range that the DHCP server uses for the other
devices in the network (provided that the DHCP server is switched
on).
• You have previously used IP addresses for the computers in your LAN.
Assign an available address from a suitable address range to your
new device. Specify whether or not the device should act as a DHCP
server in the LAN.
d If you would like to configure the IP settings manually, assign an available
address from a suitable address range to the
LANCOM Office . Also set
whether or not it is to operate as a DHCP server. Confirm your entry with
Apply .
e In the following window 'Security settings' window, specify a password
for configuration access. You may specify whether the device may only
be configured from the local network or whether remote configuration via
the WAN (via DSL or cable modem, with
LANCOM 800 Office only via
ISDN) is also permissible. Confirm your choice with Apply .
Please note that enabling this will also permit remote configuration via
the Internet. You should always make sure that the configuration access
is suitably protected, e.g. with a password.
For a LANCOM DSL/I-1611 Office or a LANCOM DSL/I-10 Office you have
just been installing the DSL interface, so that you have now the possibil-
ity to configure the ISDN interface. Confirm your choice with
Apply .
f If you have chosen the configuration of the ISDN port, you will finally be
asked, if the tariff information is also to be transmitted at your ISDN port.
Make your selection and confirm with
Apply .
g When WEBconfig reports the acceptance of the entries, the basic config-
uration has been completed.