5
Following sanitization, rinse with end-use product
until there is no aftertaste. Do not use a fresh water
rinse. This is a nsf requirement. Residual sanitizing
solution left in the system creates a health hazard.
!
CAUTION
Following sanitization, rinse with end-use product
until there is no aftertaste. Do not use a fresh water
rinse. This is a nsf requirement. Residual sanitizing
solution left in the system creates a health hazard.
!
CAUTION
Daily Cleaning
1. Using the cleaning solution, clean Top Cover and all exterior
stainless steel surfaces.
2. Clean exterior of dispensing valves.
3. Remove Drip Tray by lifting to release its mounting holes
from the mounting screws.
4. Dump water and beer, and wash the Drip Tray and Splash
Plate with cleaning solution.
5. Lift the Drip Tray to hook the mounting holes on the mount-
ing screws, and set Splash Plate on the Drip Tray.
6. Wipe clean all splash areas using a damp cloth soaked in
cleaning solution.
7. Remove the beer tap by loosening the union nut by turning it
clockwise.
8. Tilt the beer tap toward you, and run cleaning solution
through the beer tap.
9.
Refit the beer tap by turning the union nut counterclockwise.
Cleaning & Sanitizing Product Components
Lancer recommends regular maintenance and sanitization of product lines. Beer lines and taps should be routinely
cleaned as recommended by the local authorities, beer manufacturer or manufacturer of the chemical cleaner used.
Follow manufacturers’ instructions for proper use of sanitizing (or detergent) products such as recommended use-
dilution, material compatibility, storage, shelf-life, and safe use and disposal.
Ice Bin Cleaning - Start Up and Monthly
1. Remove Top Cover.
2. Remove Drip Tray by lifting it up and out from the dispenser
face.
3. Using cleaning solution, described on previous page, and
a clean cloth or soft brush, clean all sides of Ice Bin and
surface of aluminum casting.
4. Repeat Step 3 for all exterior surfaces of the unit.
5. Using hot water, thoroughly rinse away the cleaning solution.
6. Wearing sanitary gloves, soak a clean cloth towel in
sanitizing solution, described on the previous page, and
wash all sides of Ice Bin and surface of aluminum casting.
7. Repeat Step 6 for all metal and plastic surfaces (but not
labels) of the unit exterior.
8. Wearing sanitary gloves, reassemble all removable parts.
9. Fill Unit with ice and replace Top Cover.
To prevent possible harm to the environment from improper disposal, recycle the unit by locating an
authorized recycler or contact the retailer where the product was purchased. Comply with local regulations
regarding disposal of the refrigerant and insulation.
Dispenser Disposal
Summary of Contents for Breeze
Page 7: ...7 INTENTIONALLY LEFT BLANK...
