4
Handling
The projector, with or without packing, must be handled with care. Lifting and handling must be carried out with
special equipment. Do not expose the projector, with or without its packing, to brusque accelerated or decelerated
movements, knocks, dragging, or other stress caused by unsuitable handling methods.
IMPORTANT
The projector in its packing can be seriously damaged if it falls or suffers a blow during transportation.
HANDLE WITH CARE!
START-UP PROCEDURES
Positioning and Installation
Follow these steps for opening the package and installing the projector in its working position:
· Place the projector near the place it will be installed.
· Open the package and remove eventual elements and accessories.
· Carefully read the instructions in this manual.
· Prepare suitable hooks for the anchoring brackets and auxiliary support.
· Using suitable lifting equipment when needed.
· Place the projector up, close to the mounting system.
· Tighten the M12 bolts and insert a device to prevent them from accidentally loosening.
· Attach the auxiliary support element and make sure it is tightly fastened.
· Make sure all adjustable parts are locked firmly in place in the desired position.
CAUTION
You must verify the stability of the anchoring elements when the projector is in working condition. In compliance
with the laws in force, the anchoring support must withstand a load of 87 kg (Shop250) or 70 Kg (Shop150).
Screws, hooks, and hardware must be inserted correctly and installed to prevent them from accidentally loosening.
IMPORTANT
The projector was designed to function when attached to the bracket. The projector cannot function close to a flat
surface that obstructs the cooling system. Do not install the projector where there are objects located at a distance
of less than 20 centimetres from the cooling system.
Admissible environmental conditions
The projector was engineered and produced to function in covered, dry areas with an air temperature ranging
between 5°C and 35°C, and with a humidity level between 30 and 90%. Sharp changes in room temperature may
generate condensation inside the projector, which can harm the projector. Therefore, switch on the projector only
after it has undergone a period of gradual adaptation to the room temperature.
Lamp installation
· Loosen the two PH screws on the back panel (figure as above, object n°3) and carefully extract the lamp socket
group.
· Remove the lamp from the packing and carefully read the Manufacturer’s instructions.
· Position the new lamp into the socket (Shop 250: take care of the bulb polarity) without touching the glass with the
hand or any other dirt or greasy thing.
· Reposition carefully the lamp socket group and firmly tighten the two screws.
