Art. 70167
Thank you for choosing the ultra-capacitor jump starter! Always follow basic safety precautions when using
electrical appliances. Read all instructions carefully, Please keep this instruction manual for easy reference.
Display:
Key instructions:
1 Switch button: touch the switch button, LCD screen lights up.
2 Backup battery button: Press backup battery button over 2 seconds to charge the ultra-capacitor.
When LCD screen shows "JUMP START READY" and backup battery can automatically output for
ultra-capacitor after 10 seconds.
3 LED light button: Touch the LED switch to start the LED flashlight.
There are 4 modes of LED light appear in order (normal / strobe. / SOS / Off) if you press slightly.
Car battery detection
Connect Red Clamp to the positive (+) battery terminal
，
Black Clamp to the negative (-) battery terminal,checking
the voltage and inner resistance to determine if the car
battery needs to be charged or to be replaced.
FAQ:
Q: Why LCD screen shows “JUMP START READY” but can’t start the vehicle?
A: After 10 seconds “JUMP START READY” showing on the LCD screen, then can start the vehicle.
Q: Why super capacitor with 12V/10A or 5V/2A is full charging, but LCD screen still shows”
CHARGING” ?
A: This is charging for backup battery inside the product, and battery percentage will be displayed on
the LCD screen.
Parts list:
Host
Switch cable
Car adaptor
User Manual
Technical specifications:
Size: 295*219*81mm
Weight: 2000g
Backup Battery Capacity: 6000mAh
Peak current:1200A
Charing time from back-up battery to Capacitor: 3
Operating temp.: -20°C ~ 60°C / -4°f ~ 140°f
Warning:
• Read the instruction manual carefully before using this unit.
• Jump for 12V vehicles only, it would be hazard if for other jumping. It is forbidden to use for other
machines such as aircraft, ship and so on.
• Caution while using this unit.
• DO NOT use this unit if any cable clamp or cord is damaged.
• DO NOT use in place of a vehicle battery.
• DO NOT use as a battery charger.
• Never remain the unit on car battery after cranking the car success.
• Use the jumper cable provided with this unit only.
• Make sure to check all the battery connections are CLEAN before Jump Starting! Make sure the
battery clamps are well connected! If the battery terminals on the vehicle are dirty or corroded, the
power of the unit will be lessened.
• DO NOT Jump Start more than 3 times in a row. It could damage the unit by overheating. Give two
minutes between attempts. The jumping cable can become overheated and detach as a safety
measure.
• Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it could lead
to damage.
• DO NOT connect the two clamps together.
• DO NOT use by young or infirm persons without supervision.
• DO NOT use as a toy.
• DO NOT allow the product to become wet.
• DO NOT immerse the product in water.
• DO NOT operate the product in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust.
• DO NOT modify or disassemble product. Only a repair technician may repair this unit.
• DO NOT expose product to extreme heat or fire.
• Make sure someone should be within range of your voice or close enough to come to your aid when
working with batteries.
• Remove personal metal items like rings, bracelets, necklaces, etc. When using the products.
• DO NOT drop unit. If unit receives a sharp blow or is otherwise damaged in any way have it checked
by a qualified battery technician.
Warranty:
• We offer a limited warranty for this product against any defects in material and workmanship for a
period of 6 months from the date of purchase by the user/ consumer. The conditions of the warranty
are as follows:
• The warranty is only valid upon presentation of the original receipt (from dealer/retailer) by the
original purchaser with the product to be repaired or replaced.
• The warranty is void if serial number, date of purchase and label have been removed.
• The warranty does not cover damage of the product failure resulting from normal wear and tear,
phisical abuse or improper installation, misuse, modification or repairs by unauthorized third parts.
• We do not assume responsability for any loss or damage incurred during shipment or as a result of a
force majeure.
• We are not liable for any incidental or consequential damages arising from te use or misuse of this
product.
• All warranty claims are limited to repair or replacement of the defective product and only at our
discretion.
• If we repair or replace the product, this will be covered for the remaining time of the original
warranty period. Repair or replacement may involve the use of reconditioned units which are
equivalent in function. Replaced part or product become our property.
• Consumable components such as batteries are not covered by the warranty
User manual
8
Product layout:
1 LCD Display
2 Backup battery
(Boost switch)
3 Switch
4 LED switch
5 LED light
6 12V 5A input port
7 5V 2A input port
8 Battery clamps
1
2
3
4
5
6
7
8
car battery voltage
Car battery inner resistance
Capacitor voltage
Backup battery percentage
Cigarette lighter (12V - 10A)
Connect the capacitor to the cigarette lighter
socket of a vehicle powered by the supplied cable.
After 5 minutes the 15V are reached, disconnect
the starter.
3
min
5
min
8
min
40
min
Battery or emergency vehicle
Connect the black (-) gripper of the soft starter to
the negative pole of the battery or rescue vehicle.
Then connect the red clamp (+) to the positive pole.
Wait for 3 minutes until about 15V are reached and
the display will not show the word JUMP START
READY. Disconnect the starter. Any notes, warnings
and suggestions in the emergency start section must
always be checked in the vehicle's use and
maintenance manual.
Backup battery.
Press the BOOST button for 2 seconds.
After 8 minutes, when the 15V is reached,
the display will show: JUMP START READY.
MicroUSB charger (5V - 2A)
Connect the starter to the supplied
MicroUSB charger.
Wait approximately 40 minutes until the 15V
are reached, then disconnect the starter.
Flexible charging methods and jump start steps:
Charging time
Capacitor:
5V2A: 40 mins
12V10A: 5 mins
Car battery: 3 min
Back-up battery: 8 mins
Back-up battery:
5V 2A: 4 hours
12V 10A: 50 mins
Toxic and harmful substances:
Composition and amount of toxic and harmful substances in product.
Pb
Hg
Cd
Cri (Vi)
PBB
PBDE
0 0 0 0 0 0
0 Indicate all homogeneous materials' hazardous substances content are
below the MCV limit specified in the Standard 2002/95/EC(RoHs).
LAMPA S.p.A.
Via G. Rossa, 53/55 - 46019 Viadana (MN) ITALY - Tel. +39 0375 820700
UNI EN ISO 9001:2015 Certified Company -
www.lampa.it
Made in China
