3
Installing knob
As for the position of the knob, please refer to "Door
Process Dimensions" on page 2 and
"How to operate the knob" on page 4.
5
Hanging the doors
Put a support of suitable height under the doors, clip on the
hinges on the door to the mounting plates on the cabinet.
8
Checking the door movement
Open and close the door for several time and check
if the door moves smoothly. Then re-tighten the fixing
screws of all parts.
13
Installing concealed hinges, upper roller
Install Concealed hinge for Pivot side door.
Install the hinge of Sliding guide for moving door.
3
Installing center hinges
4
Countersunk head tapping screw
4 x 16 (Not included)
Spring case
Inside
Outside
Pivot side door
Fit this part on the door.
Fix the screws while pushing
the Moving door.
Pivot side door
Moving door
STEP 1 : Mount the hinge on
the Pivot side door
STEP 2 : Fix the Moving door
Fixing the mounting plates for Pivot side
door
7
Door adjustment
9
Installing Upper roller
Top board
Upper roller ①
Moving door
Adjust screw
Screwdriver
Fixing screw
Reference
pisition
(1) Insert Hinge part in
the socket part of
Upper roller, while
adjusting the height.
(2) Tighten the fixing
screw temporarily
at the reference
position.
Installing Lower roller
11
10
Bottom board
Moving
door
Lower roller - S
②
Under mount
Bottom board
Moving
door
Recessed mount
Fixing screw
Reference pisition
(1) Insert Lower roller in the
Lower rail.
(2) Insert Hinge part in the
socket part of Lower roller.
(3) Tighten the fixing screw
temporarily at the
reference position.
Raised countersunk head tapping
screws 3.5
×
15 (Not included)
Pivot side door
(Rear surface)
90°
Side
board
Top
board
Door
Forward
Up
Right
Left
Down
1
3
2
Top
board
Side
board
Door
Backward
1
2
3
Side
board
Top
board
Door
Forward
Up
Right
Left
Down
1
3
2
1
2
3
Top
board
Side
board
Door
Backward
Assembling door panels
Couple the hinge
parts as shown
in the right figure,
then insert the
hinge pin from
above.
12
Pin
Pivot side door
Moving door
Separating door panels
Pull out the pin from
center hinge as shown
in the below figure.
6
Pin
Mounting plate
⑤
Raised countersunk head tapping
screws 3.5 x 15 (Not included)
a
P
1
P
2
P
1
a
P
2
Pivot side door (Rear surface)
Periodically check if all of the screws are not loose.
If the looseness is found, tighten it.
Causion
