Installation:
1.
Screw in the studded rod (G) into the base of the tap (D).
2.
Place the upper seal (F) into the base of plinth (E) then place the base plinth (E) onto the bottom of the tap (D).
3.
Screw the hot & cold water tail pipes (K & L) into the base of the tap (D).
4.
Place the mixertap (D) onto the sink or worktop, pass the tail pipes (K & L) and studded rod (G) through the taphole.
Note: The fixing stud (G) MUST be positioned in front of tail pipes (K, L) when viewed from the front.
5.
Pass the lower gasket (H) and then metal horseshoe (I) over the studded rod (G) and around the tail pipes.
6.
Fasten the fixing nut (J) securely onto the fixing stud (G) to fix the tap into its correct location.
7.
Push out indices (A) from the rear face of handles (B). Screw on by hand handle insert (B) onto the tap handle stem (C) as shown, making sure
indices (A) are not included.
8.
Push indices (A) onto handle insert (B) as shown.
Note: Make sure indices are aligned correctly and ‘H’ and ‘C’ are placed onto the correct handles. Indices (A) is showing COLD handle.
9.
Repeat steps 7-8 for hot handle.
10. Connect the hot and cold tail pipes (K & L) to the water mains using a ½” BSP x 15mm compression fittings. Note the copper pipes can be carefully
bent to allow more space for the connecting fittings.
After installation:
Once you have visually checked the installation of the new
tap and all connections, ensure that all other fittings are
closed except the new tap which should be left open.
Turn on your water heating system and ensure that your
mains stopcock is open. Reconnect both the hot and cold
water supplies to this fitting.
Check the function of flow and function of hot, cold and
mixed water.
Turn off the tap and check carefully for any leaks around all
connections on the fitting and adjoining plumbing.
If possible return to the installation after a longer period to
double check for slower leaks. If pressure testing
equipment is available check the installation to the
maximum recommended pressure.
Clean the tap to remove any marks created during
installation as instructed then place a bag over the product
to protect the tap until it is ready for use.
The installation should be periodically checked for damage,
if the property is left unattended for a prolonged period we
recommend isolating water supplies.
Key:
Description:
Qty.
A
Indices
*
B
Coloured handle insert
*
C
Tap handle
2
D
Tap body
1
E
Base plinth
1
F
Upper seal
1
G
Fixing stud (95mm)
1
H
Lower gasket
1
I
Metal horseshoe
1
J
Fixing nut
1
K
Hot 15mm tail pipe
1
L
Cold 15mm tail pipe
1
* Supplied separately
Ref/tap4803v3
