Lamona LAM2875, User Manual

Page: 11 / 16

Refer to cleaning the grease filter in this chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter (depends on
filter type).
To reset the alarm:
Touch the for 3 seconds.
Replacing the lamp
This appliance is supplied with a LED lamp. This part can be replaced by a technician only.
In case of any malfunction refer to "Service" in the "Safety Instructions" chapter.
Troubleshooting
WARNING! Refer to Safety chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate the appli-
ance. The appliance is not connec-
ted to a power supply or it is
connected incorrectly. Check if the appliance is cor-
rectly connected to the elec-
trical supply.
You cannot activate the appli-
ance. The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
The lamp does not operate. The lamp is defective. Replace the lamp. Refer to
the "Care and Cleaning"
chapter
The appliance does not ab-
sorb enough vapours. The motor speed is not ade-
quate to the appearing va-
pours. Change the speed of the mo-
tor.
The filter alarm indicator is
on.
The filter alarm is on. The
grease filter must be cleaned. Refer to the filter alarm in
care and cleaning chapter.
The filter alarm indicator
flashes.
The filter alarm is on. The
charcoal filter must be re-
placed or cleaned. Refer to the filter alarm in
care and cleaning chapter.
11