Lamona LAM1902, User Manual

Page: 19 / 28

Troubleshooting
WARNING! Refer to Safety chapters.
What to do if...
Problem Possible cause Remedy
You cannot activate or oper-
ate the hob. The hob is not connected to
an electrical supply or it is
connected incorrectly. Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
You do not set the heat set-
ting for 10 seconds. Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more sen-
sor fields at the same time. Touch only one sensor field.
STOP+GO operates. Refer to "Daily use".
There is water or fat stains on
the control panel. Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated. You put something on one or
more sensor fields. Remove the object from the
sensor fields.
The hob deactivates. You put something on the
sensor field .
Remove the object from the
sensor field.
Residual heat indicator does
not come on. The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged. If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Hob²Hood does not work. You covered the control pan-
el. Remove the object from the
control panel.
You use a very tall pot which
blocks the signal. Use a smaller pot, change
the cooking zone or operate
the hood manually.
Automatic Heat Up does not
operate. The zone is hot. Let the zone become suffi-
ciently cool.
19