2.
Adjust the desired temperature level by touching
the and keys.
3.
Activate the timer by touching the key
“t”
symbols will blink on related cooking zones.
4.
Adjust the desired cooking time by touching
keys.
5.
After approximately 10 seconds, the setting will
be activated.
When the time set on the timer has run out, the
timed cooking zone is switched off. A timer alarm
beep sounds for one minute. But
“t”
and
“00”
symbols starts blinking constantly until touch any
key.
6.
In order to set the timer of the other cooking zone,
_15
Electrical Connections
IMPORTANT: Ensure that the electricity supply is switched off before connecting. Your hob is
intended for permanent installation.
t
e
lt
u
o
d
e
h
c
ti
w
s
e
l
o
p
e
l
b
u
o
d
a
f
o
e
s
u
e
h
t
a
i
v
g
n
ir
i
w
d
e
x
if
o
t
d
e
t
c
e
n
n
o
c
e
b
t
s
u
m
e
c
n
a
il
p
p
a
r
u
o
Y
with at least 3mm contact separation. The isolation switch must be accessible after installation (see
technical data for fuse rating). We recommend the use of an RCD device as additional protection.
We strongly recommend the appliance is registered by a competent person who will comply with the
IET and any local regulations.
The terminology DOUBLE POLE -/+ means that both the live and neutral supplies are switched and
disconnected at the same time.
The terminations labelled SUPPLY are connections for the internal house wiring and the terminations
labelled LOAD are for connection to the appliance.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:-
Blue........ Neutral
Brown......Live
Green and Yellow.....Earth
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your spur box, proceed as follows;
The appliance may be connected to the mains supply only by a competent person.
The wire which is coloured blue must be connected to the terminal which is marked with the letter ‘4’ or .
coloured ‘BLACK’.The wire which coloured brown must be connected to the terminal which is marked with
the letter ‘2’ or coloured ‘RED’ . The green and yellow earth ‘E’ should be connected to the terminal marked
with the following symbol
.
‘ ’
N
L
L
N
LOAD
SUPPLY
LOAD
SUPPLY
DP
250V~
Blue.
(Neutral)
Brown.
(Live)
Green / Yellow.
(Earth)
DO NOT connect more than 1 x hob into a double pole switched outlet
User manual LAM1749
