20
www.howdens.com
Gas Hob
LAM1113
Gas connection
These instructions are for
qualified personnel, installation
of equipment must be in line with
relevant national standard.
(For UK only: by law the gas
installation must be carried out
by a “Gas Safe” installer).
All work must be carried out
with the electricity supply
disconnected.
The rating plate on the hob
shows the type of gas with
which it is designed to be used.
Connection to the mains gas
supply or gas cylinder should
be carried out after having
checked that is regulated for
the type of gas with which it
is supplied. If it is not correctly
regulated see the instructions
in the following paragraphs to
change gas setting.
For liquid gas (cylinder gas)
use pressure regulators which
comply with the relevant
national standards.
Use only pipes, washers and
sealing washers which comply
with relevant national standards.
Adapting the hob to
different types of gas
To adapt the hob for use with
different types of gas, carry out
the following instructions:
• Remove the grids and burners.
• Insert an hexagonal spanner
(7mm) into the burner support.
Unscrew the injector and replace
it with one suitable for the gas to
be used. (See gas type table on
page 24).
To adapt the hob for use with
different types of gas, carry out
the following instructions:
• Remove the grids and burners.
• Insert an hexagonal spanner
(7mm) into the burner support.
• Unscrew the injector and
replace it with one suitable
for the gas to be used. (See gas
type table on page 24).
To replace the injectors
B
with
injectors of a size corresponding
to the type of gas to be used.
(See gas type table on page 24).
B
