LAMAX eFalcon ATV50M, User Manual

Page: 20 / 150

14
EN
CS
CS
CZ
CZ
CZ
CZ
CZ
LEFT HANDLEBAR SIDE
–
Grip
–
FORWARD/REVERSE – switch to change the direction of travel.
–
Switch (red) – turns the front headlight on/off.
–
Switch (green) – controls the horn.
–
Left rear disc brake lever – use the lever to brake the rear axle.
CHARGING SOCKET
–
The charging connector can be found under the cover on the left side under the handlebars.
SPEED SWITCH
–
A 3-position switch with a key is located on the back left
side under the seat. This switch can be used to adjust the
maximum speed.
–
L: Low speed – (8 km/h)
–
M: Medium speed – (20 km/h)
–
H: High speed – (35 km/h)
OPERATION
–
Insert the key into the ignition switch located below the battery indicator on the right side of the han-
dlebars.
–
Set the direction switch to the FORWARD or REVERSE position depending on which direction you want
to go.
ATTENTION
Never flip the switch while the vehicle is in motion.
–
Carefully twist the accelerator (throttle) grip towards you and the quad bike will start moving.
–
Stop by releasing the throttle grip.
–
Use the brake levers to stop immediately – right for the front brake, and left for the rear brake.
–
When the brake lever is pressed, the motor is automatically disengaged until the brake levers are
released again.
–
The wheels may „throw“ slightly at higher speeds.
RIDING
PROHIBITED!
Failure to follow the following instructions may result in an accident or injury.
Always apply the throttle slowly and smoothly. Rapid acceleration may result in an accident or in-
jury.
BRAKING
–
To stop, release the throttle and press the brake lever. Never brake hard.
–
Do not brake when turning. The quad bike could skid or overturn.
TURNING
–
The correct turning technique is as follows:
1. Turn the handlebars in the direction of the turn.
2. Shift your weight slightly to the inside and on the inner footrest.
3. Tilt your upper body against the centrifugal force.