2
IMPORTANT MESSAGE
When used and serviced according to this Owner’s Manual, this device can greatly increase your chances of survival in the water. The lifejacket has integrated polyvinyl
chloride material cover which is easy to clean.
The lifejacket cover closure system is a simple hook and loop fastener or zipper (depending on product code). The cover will pop open quickly upon discharge of 1 or 2
cylinders of 33gr or 60 gr CO
2
automatically upon water entry, or manually by pulling the manual lever. When filled, its chamber capacity is capable of providing buoyancy
to keep the wearer’s head above water. Actual buoyancy will vary with ambient conditions and CO
2
production tolerances.
A double oral & relief inflation tube with automatic seal valve is provided for buoyancy adjustment and deflating. Oral inflation may only be used as a back- up if for any
reason the automatic and/or manual inflation has not operated.
LALIZAS Lamda lifejackets can be easily adjusted to users with chest size up to 150cm.
When fully donned and inflated, this device is designed to turn most wearers face up within 5 seconds.
Its inner high visibility yellow chamber, with double chamber interlocking system and SOLAS grade retro-reflective material, its SOLAS lifejacket light and whistle, which is
firmly secured by lanyard, enhance the chances for rapid rescue. The lifejacket has also integrated a yellow lifeline, also known as buddy line, which is reusable and can
be secured to a lifejacket worn by another person in the water.
It is also provided with lifting loop so as to lift the wearer from the water into the rescue boat or survival craft.
The LALIZAS JSI inflator mechanism was selected for its low profile, simplicity, and field proven technology. Its water-soluble water activation device technology meets
the highest inflation mechanism requirements for resistance to inadvertent inflation from high temperature and high humidity. Caution: Since water soaking trips the firing
pin, premature inflation is always a possibility with all inflators. Rain, splash, and fog are very unlikely to cause firing. Full immersion as would be experienced with a large
wave or fall overboard will cause inflation.
Attention: The inflator mechanism does not have cylinder seal indication, so the cylinder must be removed to check and confirm that it has not been fired. Once the
lifejacket is used, then it should be immediately serviced and immediately cylinder CO
2
to be replaced with a brand new cylinder CO
2
.
CAUTION
DEVICE
IS
ARMED
READ INSTRUCTIONS IN YOUR OWNER’S MANUAL PRIOR TO USE
SEE PARTS LIST BELOW
GENERAL SPECIfICATIONS
Chest Size:
70 - 150 cm
Weight Range:
more than 40 kg
Buoyancy:
150
,
275 & 330 Newtons according to each model predefined category, when fully inflated
Inflation System:
2 pcs of Manual/Automatic Inflation Mechanism
2 pc Oral & Relief Tube (Double)
The Manual levers
are used to manually activate the inflation mechanism and inflate the lifejacket.
2 pcs of CO
2
Cylinder
33 or 60 gram in accordance with the relevant model, 1/2-inch thread
Available in one adult size, which can be easily adjusted to passengers with chest size up to 175cm or more, with the use of the LALIZAS Waist Belt Extender (71161)
PRE-DONNING INSTRUCTIONS
CHECK THE FOLLOWING INSTRUCTIONS BEFORE EACH USE OR OUTING:
1. INSPECT THE LIFEJACKET FOR DAMAGE
2. INSPECT THE INFLATOR MECHANISM/S
3. EXAMINE CO
2
CYLINDER CAP FOR PUNCTURE HOLE. IF PUNCTURED OR DEFORMED, REPLACE THE CYLINDER.
4. CHECK THAT THE STATUS OF THE INFLATOR IS IN AUTOMATIC OR MANUAL MODE FOR THE APPLICATION NEEDED.
DONNING INSTRUCTIONS
In an emergency situation there is not enough time to learn the proper operation of lifesaving equipment. Therefore, it is advised that the user has practiced beforehand,
in order to become familiar with the use and features of the lifejacket. It is vital that the lifejacket is correctly adjusted in order to fit the user.
Donning instructions are printed on the outer cover of each lifejacket.
LALIZAS
