6
8.
Position the saw holder as shown,
aligning the brackets with the pilot
holes. Use the 2 saw holder screws
to secure the holder.
9.
Now it’s time to use a little muscle. Tighten every screw and bolt all
the way in! (A socket wrench will make this task easier.) Once
everything is secure, turn the workbench over.
10.
From the side, slide the bottom shelf between the legs and drop it
into place.
Dark panel
faces inside.
5
6.
Position the vise on the pre-attached vise block as shown below.
Make sure the left edge is flush with the table. Then, use a hammer
and nail to create four starter holes in the vise block. To do this,
simply tap a nail into the vise block using the holes in the vise as a
guide.
7.
Use 4 screws to secure the vise.
Note:
You’ll only need to tap the nail once or twice.
