11
INSTRUCTIONS FOR USE
• Make sure the 2-in-1 Stand Mixer is unplugged and on a level, dry surface.
• When you switch on the appliance for the first time there may be a slight burning smell,
this is normal and will stop after a few uses.
• Press the release lever on the stand and raise the
cradle.
• Place your ingredients into the mixing bowl.
• Press the release lever on the stand and lower the mixer until it clicks into place.
• Always make sure the speed switch is at ‘0’, then plug in and switch on the hand mixer at
the socket.
• Slide the speed switch to the first dot.
• Use the speed switch, sliding up or down to select your desired speed. Start off on the first
dot and then increase the speed as required.
• If you require a short fast burst of speed, slide the button to ‘P’ pulse whilst mixing.
• When your mixture is ready, move the speed switch back to ‘0’, the beaters or dough
hooks will continue to rotate for a few seconds after being switched off, wait until they
have fully stopped before handling.
• Lift the mixer using the release lever on the stand.
• The beaters and dough hooks can only be removed when the speed switch is in
the ‘0’ position.
• When using as a hand mixer - ‘P’ pulse can also be used at the end of mixing to clean your
beaters, lift them above your mix (keeping them still in the bowl), slide to the ‘P’ and back
to ‘0’ to remove excess mixture before you finish.
• Switch off and unplug the hand mixer at the socket.
• To remove the beaters and dough hooks, hold them with one hand, press the eject button
with the other and pull to release.
WARNING
: Always switch off and unplug the appliance before you attach or remove the
beaters or dough hooks. Avoid contact with moving parts to avoid risk of injury and damage
to the appliance. Do not put your hands or utensils inside the mixing bowl while using the
mixer.
