INSTALLING YOUR ANYWHERE SENSOR LIGHT
• Your light is weather resistant so it can be used indoors or outdoors.
It can be stood on its base, or fixed to a wall.
• To fix to a wall, determine where you want to install the light.
• Remove the screw from the centre of the base.
• Hold the base against the wall and mark the centre of each hole using a pencil/marker.
Make sure the narrow ends of the holes are facing upward.
Replace the base and screw onto the light.
• Drill and plug the three holes marked on the wall and simply insert a screw into each
hole leaving 3mm of the screw above the wall surface.
• Match the holes on the base of the light with the screw heads in the wall and slide
downwards to secure the light fixture.
3
Screw
Holes narrow
end facing up
Base
INSTRUCTIONS FOR USE
• Slide the ON/OFF switch underneath the battery compartment to the ON position.
• Adjust the light to shine in any direction. The base rotates 360° and the lamp pivots
vertically to any angle.
• The motion sensor light detects motion within a 90° angle up to 10 feet away and
stays lit for 30 seconds.
