Lakeland Mills CF2626, Assembly Instruction

Page: 1 / 4

CF2626 DOUBLE CHAIR LOG SWING
Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the
store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly
for you.

Read all instructions before start-
ing.

To start hex washer head screws, hammer into
wood about 1/2” then use wrench or socket to
tighten.

Do not completely tighten any screws until the
unit is fully assembled and setting on a level
surface.

Use a rubber mallet (or a block of wood be-
tween the hammer and the unit) to drive dow-
eled ends into holes as far as possible.

A battery or power drill makes assembly faster
and easier.
YARD SWING COMPONENTS
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered de-
fects
.
TOOLS REQUIRED
NOTE:
YARD SWING HARDWARE
(Shown smaller than actual size)
1 - Top Rail
4 - 24” Arms
2-Preassembled Swing Backs
2-Preassembled Swing Seats
4 - 45”
Swing Bars
4 - Seat
Ends
Twenty
Screws
Four3/8” x 5”
Eye Bolts
Four Barrel
Nuts
Two 3/8”
Nuts
Eight
1/4” x 5”
Hex Washer
Head Screw*
Eight 3/8”
Washers
Two
3/8” x 8”
Bolts
Twelve
1/4” x 3”
Hex Washer
Head Screws*
Rubber
Mallet
Block of
Wood
& Hammer
Tape Measure
Regular
Screwdriver
or
Pencil
4 - Legs
6 - 34 3/4” Braces
Four1/2” x 6”
Eye Bolts
Four 1/2”
Nylock Nuts
Eight 1/2”
Washers
Four S
Hooks
4- 12”
Arm Supports

3/4” deep well
socket

9/16” deep well
socket

9/16” wrench

7/16” socket or
wrench

3/8” socket or
#2
Philips
Screwdriver
* Hex Washer
Head Screws may
be substituted
with Lag Screws
and Washers.
Optional