STEP 8
STEP 9
STEP 10
Factory: 1 Lakeland Place, Edmore, Michigan 48829, Phone: 800-427-5136 Fax: 989-427-5824
www.lakelandmills.com
Place barrel nut into horizontally drilled hole
in end of swing bar. Position barrel nut with
screwdriver and screw in 5” eyebolt with
3/8” washer as shown.
TIGHTEN DOWN
SECURELY!
Repeat on other swing bar.
Figure 7.
Fasten swing bars to side of unit as shown in Figure 8.
With hammer, tap a 5” hex washer head screw through
the bottom hole in swing bar and into pilot hole (11” from
the back of the seat end) on seat end. Tap 5” hex washer
head screw through the upper hole in the swing bar and
into arm about 1/2” deep at the point 15” from the back of
the arm. (
This gives a suggested pitch of the seat. You
may change the pitch by altering the location of the hex
washer head screws in the arm.)
Tighten down hex
washer head screws. Figure 8.
Install the assembled swing to the frame. It is recom-
mended a minimum of two people for this this step.
Figure 9.
STEP 11 Tighten all hex washer head screws firmly. Your unit is
now ready for finishing or immediate use. Relax and enjoy.
Check all nuts and bolts for tightness before
and during each usage season.
NOTE:
SEAT TO FRAME ASSEMBLY
IMPORTANT-
If you have hardware left over after complet-
ing your unit, it most likely has been assembled incorrectly,
and may not be safe to use. Please call Customer Service at
800-427-5136 for assistance.
Install on level ground. Install not less than 6’ from any
obstructions such as a fence, garage, house, overhanging
branches, lines, or wires.
figure 9
figure 7
figure 8
Look for videos on:
https://www.youtube.com/watch?v=jg2BRgWMVpg&t=1s
https://www.youtube.com/watch?v=-OmqxSrmkYM
Finishing Tips:
Use a good quality penetrating oil or wood deck sealer
with a UV inhibitor.
If staining or finishing before assembly, tape off all
dowel ends. (Finishes will cause dowels to swell, making
assembly difficult.)
Lakeland Mills recommends:
WeatherSeal Premium Oil-Based Exterior Wood Stain &
Sealant
www.ContinentalProd.com
Summary of Contents for CF2626
Page 2: ...24 22 1 2 ...
