Lakeland Mills CF1128, Manual

Page: 3 / 4

SEAT ASSEMBLY
STEP 4 Lay assembled seat on ground. Insert doweled
ends of uprights on assembled back into 1-
1/4” holes on the back seat rail, adjusting up-
rights in or out as needed to align properly.
Do not tap on seat back with hammer.
To keep the seat rail from splitting, lay the
back on the ground and drive the seat on by
hitting on the bottom of the seat assembly.
STEP 5 Insert 12” arm support into hole in the arm,
then into hole in the top of the seat end.
Drive doweled ends in as far as possible.
Fasten arm to the back upright by tightening
the preinstalled 1/4” x 5” hex washer head
screw into the pilot hole in the arm with a
wrench. Repeat on other arm.
STEP 6 Secure all doweled joints in place with screws
perpendicular to the doweled end as shown at
right.
Install seat end onto seat. Align holes in seat end with
dowels on seat as shown in picture right. Repeat on
other side. Secure with screws perpendicular to dowel.
(See circle figure below). IMPORTANT: The single
hole
should be placed toward the front of the seat. (See
below).
STEP 4a
Please Note : After you have installed the seat ends onto the
seat secure with (4) 2 1/2” screws. See figure below for how
to put screws in..