Make a right leg set and a left leg set by
inserting dowel end of back leg into angled hole
of front leg. The drilled holes on each leg should
face the same direction as shown in figure 2.
Put arms onto legs by inserting dowel end of front
legs into the hole in the arms. Drive arm onto leg
assembly as far as possible.
Lay back and seat assembly on its side and
insert dowel ends of seat rail into holes on leg sets.
Drive legs on as far as possible. Turn assembly over
and repeat procedure for the other side.
Set chair in upright position on a level surface and
when legs are in proper position, bring ARM in against
UPRIGHT. Tighten the preinstalled lag screws into the
pilot hole in the arm with a wrench or socket.
Secure doweled joints in place with screws perpendicular to
the doweled ends as shown in figure 4 and figure 6. Repeat
procedure for other side.
Tilt chair back and screw a brace on each side of front
leg to chair bottom as shown in figure 5.
Set unit on a level surface and tighten down all
lag screws firmly to secure unit. Secure all dowel
joints in place with screws perpendicular to the
doweled end as shown in figure 6.
Your chair is now assembled and ready for finish or
immediate use.
Factory: 1 Lakeland Place, Edmore, Michigan 48829, Phone: 800-427-5136 Fax: 989 -427-5824,
www.lakelandmlls.com
Check all joints for tightness before and during each usage season.
If you have hardware left over after completing your unit, it most
likely has been assembled incorrectly, and may not be safe to use.
Please call Customer Service at 800-427-5136 for assistance.
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
https://www.youtube.com/watch?v=VjvdmG34Oqw
Look for assembly videos on:
Upright
NOTE
https://www.youtube.com/watch?v=zLXo9pETXa4
Lakeland Mills recommends:
WeatherSeal Premium Oil-Based Exterior Wood Stain & Sealant
www.ContinentalProd.com
