background image

Products for Dust Handling

Lajac AB  l  www.lajac.se  l  Maskingatan 10  l  S-702 86 Örebro  l  Tel: +46 (0) 19 32 00 87  l  [email protected] 

HOSR/-EX

USERS MANUAL

Tighten hose reel spring

Placement/mounting

The hose reel is supplied as standard for wall mounting but can be obtained for ceiling mounting or on an extension arm up to 3 m. Unless 

otherwise stated in order, wall mounted hose reel is delivered as standard. When retrofitting a ceiling, there is a supplementary arm guide, 

which makes the angle right for ceiling mounting. Hose reel is lifted into place by means of either fork lift, hydraulic platform or the like.

WALL MOUNT

CEILING MOUNT

MOUNTED ON ROTATABLE EXTENSION ARM

Pull out the hose at 

least 2 meters and 

until it reaches the 

locking position.

Pull the hose 

between the reel 

and the arm.

Place the hose 

over the reel 

again.

To tighten harder, pull out so much hose that you can put it over the reel 2 times. Note that the spring can go into locked position if it is 

tightened too much, then it is also not possible to roll out the entire hose. There is also a risk that the spring will go off. In order to reduce 

the strength, the steps in the description are done in reverse order.

Hose is pulled out to the necessary length, whereafter it is locked by letting the hose move back in locked position. Hose is released by pul-

ling the hose forward to unlocked position and hereafter letting it roll back. Slowly roll the hose back while gently guide it by hand until hose 

stop is reached. It must frequently be checked, whether the locking device is working without failure. Hose stop must be undamaged. Spring 

cabinet may only be taken apart by especially trained personnel. May only be used with sufficient fan extraction.

Hose reel operator or others must always be in such a distance from the hose reel to avoid getting in contact with it. Hose reel HOSR may 

only be used for dust extraction. Max. 60° C (EVA hose). Longer hoses and other types than the original may not be mounted, since it can 

damage the spring. If no hose stop is used, it must be ensured that at least 1.5 m hose hangs down in locked condition to prevent accidents.

The hose should at any circumstances never be stepped on or dragged against sharp elements, always roll up the hose when not in use.

Usage/maintenance

Drawing standard hose reel HOSR-38/-50

Reviews: