SDC-CF22AG
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
15
© Copyright 2015 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
IMPORTANT NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
Industry Canada
User’s Guide Requirements
As outlined in the Operational Description, the SDC-CF22AG complies with Industry Canada (IC) rules for
a Limited Modular Approval. To leverage Summit’s grant, the two conditions below must be met for the
host device into which the SDC-CF22AG is integrated:
1.
The antenna is installed with 20 cm maintained between the antenna and users.
2.
The transmitter module is not co-located with any other transmitter or antenna that is capable of
simultaneous operation.
As long as the two conditions above are met, further
transmitter
testing is typically not required. However,
the OEM integrator is still responsible for testing its end-product for any additional compliance
requirements required with this module installed, such as (but not limited to) digital device emissions and
PC peripheral requirements.
I
MPORTANT
!
In the event that the two conditions above
cannot be met
(for example certain
device configurations or co-location with another transmitter), then the IC
authorization is no longer considered valid and the IC ID
cannot
be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
IC authorization.
When using Summit’s IC grant for the SDC-CF22AG, the integrator must include specific information in the
user’s guide for the device into which the SDC-CF22AG is integrated. The integrator must not provide
information to the end user regarding how to install or remove this RF module in the user’s manual of the
device into which the SDC-CF22AG is integrated. . In addition to the required FCC statements outlined above,
the following IC statements must be added in their entirety and without modification into a prominent place
in the user’s guide for the device into which the SDC-CF22AG is integrated:
To prevent radio interference to the licensed service, this device is intended to be operated indoors and
away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed
outdoors is subject to licensing.
European Union
User’s Guide Requirements
The integrator must include specific information in the user’s guide for the device into which the SDC-CF22AG
is integrated. In addition to the required FCC and IC statements outlined above, the following R&TTE
statements must be added in their entirety and without modification into a prominent place in the user’s
guide for the device into which the SDC-CF22AG is integrated:
This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test
methods have been applied in order to prove presumption of conformity with the essential requirements
of the R&TTE Directive 1999/5/EC:
EN60950-1:2001 A11:2004
