Pigtail Mount Side Exit:
Looking at the bottom of the unit there is a black line on the protective paper on the foam backing. This line extends from
the center of the housing to the edge. With a razor knife, trim away on both sides of this line to create a slot that lines up with the hidden groove under it.
Now remove the caulking material that fills the hidden groove. The coax will lay in the groove when the antenna is installed on any flat surface.
Hole Mount:
When you have decided on a mounting location, mark the center of the locations and drill an 3/4” hole with the
X-ACT™ HS34 hole saw. Then, using a MB8 mounting kit, screw the
Discadoo
™ onto the mount. Please note that the internal design of the antenna will
show a DC short on the pigtail version and a DC open on the NMO version when measured with an OHM meter between ground and center conductor.
Magnetic Mount:
Simply set the magnetic mount
Discadoo
™ on a metal surface free of metal obstructions either 4” beside or above the antenna.
No Ground Plane Model:
The no ground plane antenna’s tuning is strongly affected by any metal in the area of the antenna, above, adjacent to or
below it. The same applies to how the coax is draped as it leaves the antenna. Use a wattmeter or other SWR analyzer, take care to position the antenna free
from obstructions, and adjust the coax to drape for the best possible installation.
Note: The Discadoo™ can be painted with nonmetallic paint to match any car or to mount in a building, on a wall or on a ceiling.
Warranty:
Laird Technologies warrants to the original purchaser that our antennas will
remain free from defects in materials and workmanship for a period of 1 year from the
purchase date. If any such defect is discovered within the warranty period, Laird Technologies
will at its sole option, repair or replace your product free of charge. This warranty applies
only if the product is used as designed, and is void if the product is abused, disassembled,
tampered with, used unreasonable or fails as a result of normal wear. Furthermore, this
warranty applies only to defects which occur where the proper product is selected as
recommended by Laird Technologies and is used in the fashion recommended by Laird
Technologies for the defective product. This warranty is in lieu of all other warranties,
expressed or implied, and is limited to a period of one year from the date of original purchase.
Laird Technologies is not liable for incidental or consequential damages of any kind. Any
warranty extended herein shall be limited to the price paid to Laird Technologies for the
defective product. Where the period of warranty is governed by state or local law such period
shall control.
©Laird Technologies-All Rights Reserved
Tel: 847.839.6000 • Fax: 847.839.6036 • www.lairdtech.com
L:\Instruction Sheet PDF’s (Shop)\ANT_IS_DISCADOO 0911.pdf
