Bx600 Series of Breakout Boards for BL600 module
User Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/bluetooth
18
Laird
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Table 1: nAutoRun settings
J5 pin2
Comments
nAutoRUN
(SIO_28)
Pin 40 of
BL600
Input with active low logic
Operating mode selected by nAutoRUN pin status:
If LOW (0V), runs $autorun$ if it exist. (Insert jumper between J5 Pin 2 and Pin 1)
If HIGH (VCC), runs at+run and file name application (Insert jumper between J5 Pin 2 and Pin 3)
To initiate autoRUN, follow these steps:
1.
Start by loading a smartBASIC application that can run from autoRUN at power up (
Figure 13
).
Figure 13: Load smartBASIC application
2.
In UwTerminal, do a compile and download and select $autorun$.iBeacon.sb (for example).
Figure 14: Compile and download
3.
Verify that the application exists as $autorun$ by issuing at+dir.
4.
Unplug the Laird FTDI USB-UART bridge board.
5.
Install a jumper between pins 1 and 2 of J5 (nAutoRUN set to Low to put module into autorun mode).
6.
Install a coin cell battery (CR1632)(
Figure 15
) in the slot on the bottom of the module.