laguna T1002, Manual, Page: 18 / 49

Note: There are 2 sets of holes in the table to extend the range of the fence.
3.
Fit the hold down and the hold in.
4. The shaper fence is now assembled to the machine.
5. The steel bar on the table has a rule to assist you in setting and
adjusting the shaper fence.
6. To adjust the fence forward or back, leave the side ratchet handle
clamped, release the top clamp knobs that clamps the assembly to the
table and adjust the knob that is located at the back of the assembly
[this knob will move the assembly forward or back]. Once the required
adjustment has been made, reclamp the top clamp knobs.
7. To adjust the left hand fence, [when viewed standing infront of the
machine] rotate the knod at the back of the assembly.
Hold down and hold
in assembly
Fitting hold down
& hold in assembly
Side ratchet
handle
Back view of shaper
fence assembly
Adjusting the fence bars
To adjust the sliding fence bars [fingers], loosen the socket head allen set
screws, slide the bars to the required position and clamp using the socket
head allen set screws.
17