laguna SHEARTEC II PX-22, Owner'S Manual

Page: 19 / 83

General Information 19
insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor.
If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor
to a live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood,
or if in doubt as to whether the tool is properly grounded. Use only 3-wire extension cords that have 3-Prong
grounding plugs and 3 pole receptacles that accept the tool's plug. Repair or replace damaged or worn cord
immediately.
2.) Grounded, cord-connected machines intended for use on a supply circuit having a nominal rating less than 150 volts:
This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in
Fig. A.) The tool has a grounding plug that looks like the plug illustrated in Fig A.) A temporary adapter, which
looks like the adapter illustrated in Fig B may be used to connect this plug to a 2 Pole receptacle as shown in Fig.
B.) if a properly grounded outlet is not available.
The temporary adapter should be used only until a properly
grounded outlet can be installed by a qualified electrician. This adapter is not permitted in Canada. The
green-colored rigid ear, lug, and the like, extending from the adapter must be connected to a permanent ground
such as a properly grounded outlet box.
3.) Grounded, Cord-Connected tools intended for use on a supply circuit having a nominal rating
between 150 – 250 volts, inclusive:
This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in
Fig. C. The tool has a grounding plug that looks like the plug illustrated in Fig. C. Make sure the tool is
connected to an outlet having the same configuration as the plug.
No adapter is available or should be used
with this tool. If the tool must be reconnected for use on a different type of electric circuit, the reconnection should
be made by qualified service personnel; and after reconnection, the tool should comply with all local codes and
ordinances.