laguna MPLAN25-15-3-0130, Operating Manual, Page: 6 / 43

5
Dust Chute Assembly
Mount the dust chute to the planer hood
with eight M6x10 hex head screws B.
Make sure the dust collection system has
sufficient capacity and suction for your
planer. Always turn on the dust
collection system before starting the planer.
(Fig. 2)
Table Roller Handle Assembly
Thread the handle C (Fig. 3) into the hub.
Control Panel
In Fig. 3
D: Emergency Stop Button: Stops all
functions of machine, but the planer still
has power. To reset rotate switch
clockwise until the button pops out.
E: Main Motor: Starts rotation of
Cutterhead. Will not work if the
“Emergency Stop” switch is engaged, or
hood is open.
F: Digital Thickness Controls: Displays
and controls table position, units, etc..
G: Table Up: Raises the table.
Note: Table will contact the upper limit
switch at about 5/8”. You can continue
to raise manually by using the
handwheel.
H: Table Down: Lowers the table.
Note: Table will contact the lower limit
switch at about 8-5/8”. You can
continue to lower manually by using the
handwheel.
Note: Do not feed material through the
planer while the table is raising or
lowering.