8
3 4
2
9
1 6 7 8 5
1.
Out feed Table.
2.
In feed Table.
3.
Fence.
4.
Cutter head Guard.
5.
Electrical cable.
6.
Table height adjusting handles.
7.
Body.
8.
Mobility kit.
9.
Start and stop switches.
Out feed Table.
The function of the out feed table is to support the job once it has been machined
by the cutter head. The out feed table must be adjusted level with the cutter head
teeth at top dead centre [TDC].
In feed Table.
The in feed table is adjusted to suit the depth of cut that is required.
Note.
Never exceed the maximum depth of cut specified for your machine. It is far
safer to take many small cuts rather than one large cut.
Fence.
The fence is used to keep the job square to the cutter head and is also used to
produce angle cuts on the edges of panels. The fence can be adjusted from 90 to
45 degrees.
Cutter head Guard.
The guard is there to protect you. Always adjust the guard to expose only the
minimum amount of cutter to suit the job width.
Electrical cable.
Note.
The machine may not be supplied with a plug as the plug type will depend
on your electrical supply.
Table height adjusting handles.
The hand wheels adjusts the tables to the required height.
Body.
The body of the machine supports the table etc. It is manufactured from heavy
gauge steel and provides a heavy base that is designed for rigidity.
Mobility kit.
The mobility kit allows the machine to be moved to various locations within your
work area.