laguna Fusion 3, Owner'S Manual

Page: 9 / 81

Fusion 3 Table Saw \ Electrical Safety \
© 2020 Laguna Tools 9
Electrical Safety
Power Connections
A separate electrical circuit should be used for your machines. This circuit should not be less than the wiring listed below
and should be protected with an appropriate circuit breaker based on the total running and start-up amperage's (listed
below). If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and
matching receptacle which will accept
the machine’s plug.
Before connecting the machine to the power source, make sure the switch is in the “OFF”
position.
MTSF3362203-0130-36
VOLTAGE 220V
PHASE 1PH
HERTZ 60Hz
FULL LOAD AMPERAGE 14.8A
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables outside of our control are:

Actual voltage supplied to the machine

Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
PLUG/RECEPTACLE
6-15
WIRING (Gauge)
14 Ga. (minimum)
CIRCUIT BREAKER / (Fuse)
20AMP / (20 AMP Slow Blow)
MTSF3362203-0130-52
VOLTAGE 220V
PHASE 1PH
HERTZ 60Hz
FULL LOAD AMPERAGE 14.8A
Below are RECOMMENDATIONS to be used for this machine based on the above
information. Variables outside of our control are:

Actual voltage supplied to the machine

Electrical code that must be met in your local province.
An electrician will verify that all the demands are met to properly wire the machine. If you have
absolutely any doubt when wiring this machine - please consult with a qualified electrician.
PLUG/RECEPTACLE
6-15
WIRING (Gauge)
14 Ga. (minimum)
CIRCUIT BREAKER / (Fuse)
20AMP / (20 AMP Slow Blow)