laguna Fusion 2, Setup And Maintenance Manual

Page: 26 / 45

Fusion Tablesaw
26
There is a 101.6 mm dust outlet located on the lower left of the saw cabinet allowing for the
connection to a dust collection system (not included).
Air current speed is 20m/s for vacuum suction dust emission index. When air current speed of dust collector device (in accordance with EN
12779:2004+ A1:2009) is not lower than 20m/s, ensure machine can be normal exhausted. User must wear dustproof mask.
1. Fit the 4" dust hose over the dust port, (not included) and secure in place with a hose clamp.
2. Make sure the hose could not come off.
3. Required air flow: 934 m
3
/h
4. Ensure pressure drop of each dust collector outlet carrying air current speed: 1500Pa
5. Wind speed of dust collector tube m/s: dry chips: 20m/s, water content is equal to18% wet chips: 28m/s.
To clean wood chips
Remove the side cover, to clean and remove dust, debris from dust Hood
PUSH Block and Push stick
A push block ( Fig.2 ) and A push stick ( Fig.3 ) must be used
Warning: Always turn on the dust collector
before starting the saw and stop the saw before
turning off the dust collector.
Note:
A tight fit is necessary for proper performance.
Warning: Always turn off the table saw before removing
any cover of the machine
Warning: Use only the push stick provided by the
manufacturer or constructed in accordance with the
instructions. This push stick provides sufficient distance of
the hand from the saw blade.
Warning: Never use a damaged or cut push stick. A
damaged push stick may break causing your hand to slip
into the saw blade.
If the workpiece is less then 120mm, you must use the push stick to
prevent your hands from getting too close to the saw blade.
push block must be used to cut narrow workpieces
and, when necessary,
to push the workpiece against the fence, a push block can be easily made
by the operator as
Fig.2 ,