Laguna Tools Tools-PX-22 SHEARTEC II, Owner'S Manual

Page: 35 / 80

35
Power Supply Circuit Requirements-
The power source circuit for your machine must be grounded and rated for the amperage
given below. Never replace a circuit breaker on an existing circuit with one of higher amperage
without consulting a qualified electrician to ensure compliance with wiring codes. If you are
unsure about the wiring codes in your area or plan to connect your machine to a shared circuit,
consult a qualified electrician.
Circuit Size (220V-Volts, [1P] Single Phase) ........32 Amp (minimum)
Motor Specifications-
The typical main motor is 7.5 HP and is typically wired for 220 Volt, Single Phase, 60 HZ, AC
current. Confirm your motor electrical configuration before connecting power! Before connecting
the machine to the power source, make sure the starter and switches are in the "OFF" position.
Cord and “plug” are NOT included. These must be installed by a Qualified Technician/Electrician to
local codes.
NOTICE! A “Electrical Plug” and “Power Cord” are NOT included and must be installed by a
Qualified technician/Electrician , or the power cable connected (hard wired) to an appropriate
disconnect according to local codes.
DANGER!- IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY
GROUNDED. IF YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN CHECK THE RECEPTACLE.