17
Lower the Timbermaster until it is in contact with the bandsaw table. Remember to
raise the inner levelling feet off the floor until all adjustments have been completed.
1/
Loosen all the roller nuts
on one cabinet and push
the wheels down to the
bottom of the slots.
2/
With the sliding table
over the bandsaw table,
position it so that it is over
the first wheel
3/
Holding both outside
nuts, pull the wheel up until
it contacts the sliding table
and hand tighten the two
outer nuts.
4/
Then tighten both nuts
on one side then the other
side.
5/
Check that the wheel is in contact with the plate.
Move the sliding table to the next wheel and repeat.
6/
Continue until all the wheels on that side have been
adjusted.
7/
Repeat for the other cabinet.
8/
Jack the unit until it is just clear of the band saw
table. Lower the inner feet until they contact the floor
and take the weight of the Timbermaster. Ensure that
you do not jack the inner feet excessively or they will
cause the timber master to rock.
Sliding table
Cabinet wheel
Wrenches
