Laguna Tools Pro Widebelt Series, Manual, Page: 20 / 43

FEED SPEED PRESSURE ROLLER
(FOR VARIABLE SPEED ONLY) The front and rear pressure rollers have been factory adjusted. However, if
The feed speed adjustmnt is infinitely variable in order to meet the sanding further adjustment is ever require, proceed as follows:
requirements of a wide variety of materials. In general, soft woods require 1. Stop machine
a higher feed speed, while hard woods require a lower feed speed. 2. Place a sanded panel on the conveyor belt and under the rollers. The panel
However, correct feed speed selection is largely a matter of experience. should be long enough to contact both front and rear rollers. Raise the table
until panel contacts the rollers.
3. Make sure the pressure at the right and left side of pressure rollers is even
4. Loosen the fix nut then turn the adjustment knob as shown in Figure 14.
5. When parallelism is satisfactory, retighten the fix nut.
CHANGE THE FEED SPEED ONLY WHILE THE MAHCINE IS
RUNNING.
Adjust the feed speed with the speed selector knob of the worm gear
reducer. Figure 13 , and the speed adjustment valve of the hydraulically
driven conveyor belt. Turn the feed speed selector knob clockwise to
decrease the conveyor belt speed, counter-clockwise to increase it.
Figure 13
Figure 14
15
CAUTION !!