26
Motor Tries To Start But Will Not Turn
1
. With the power disconnected from the machine try to turn the spindle by
hand. If the spindle will not turn, check the reason for the jamming.
2.
Motor faulty. Replace the motor.
3.
Spindle run with out coolant. Replace the motor.
Motor Overheats
The motor is designed to run hot, but should it overheat, it has an internal thermal
overload protector that will shut it down until the motor has cooled, and then it will
reset automatically. If the motor overheats, wait until it has cooled and restart. If
the motor shuts down consistently, check for the reason. Typical reasons are dull
cutting tools, no water in the coolant tank, blockage in the coolant pipe and
excessive ambient temperature.
Squeaking Noise
1
. Check the bearings.
Spindle Slows Down During A Cut
1
. Dull cutting tools. Replace the tool or have it re-sharpened.
2
. Feeding the wood too fast. Slow down the feed rate.
Machine Vibrates
1
. Machine not level on the floor. Re-level the machine ensuring that it has no
movement.
Summary of Contents for MCNC Swift 48 X 48 1000-0233
Page 2: ......
