Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
#972200, 972210, 972220
13
REV#072020
Step 5:
-
Using two 10mm x 120
mm bolts, washers, and nuts, snug only enough to allow plate to travel.
Step 6:
-
Install the pumping device to the mounting plate using 2 M10 x 25mm bolts, nuts, and
washers. Make sure pump is aligned in the center on this mounting plate for proper installation.
Step 7:
-
With press standing upright and all bolts tightened install the worktable. Insert two table pins in
the two lowest holes. Take the worktable and tilt it at a sharp angle and insert it in the uprights.
(NOTE: The gussets welded to the table are at slight angles. The narrowest dimension of
these gussets goes down. See drawing) (Step 1) Once worktable is in the uprights turn it level
and lower down and set it on the table pins. (Step 2) Take care when doing this, a helper
would be advised.
