![Laguna Bay Spas Spa Owner'S Manual Download Page 6](http://html2.mh-extra.com/html/laguna-bay-spas/spa/spa_owners-manual_3299058006.webp)
manner, there may be an electrical malfunction and with it, the possibility of
an electric shock. Disconnect the power until the problem has been corrected.
Please note this action will automatically reset the filter cycle of the spa.
220 VOLT, PERMANENTLY INSTALLED MODELS:
A ground terminal is provided on the terminal block located
inside the control box. To reduce the risk of electric shock,
connect the terminal to the grounding terminal of your electrical
service or supply panel with a continuous green, insulated copper
wire. A bonding terminal (pressure wire connector) is provided
on the outside of the control box for bonding to local ground
points. To reduce the risk of electric shock, this connector
should be bonded with solid copper wire to any metal ladders, water pipes, or
other metal within five feet (1.5m) of the spa to comply with local requirements.
The means of disconnection must be readily accessible, but must be installed at
least five feet (1.5m) from the spa.
DO:
Make sure your spa is properly connected
- USE A LICENSED ELECTRICIAN
Disconnect the spa from the power supply
before draining and servicing
components.
Test the Ground Fault Interrupter(s) before each use.
Replace damaged wires and cords immediately
to reduce the risk of electric
shock. Failure to do so may result in death or serious permanent injury by
electrocution.
DON’T
Use the spa with the equipment compartment door removed.
Replace components except with identical components
supplied by the
manufacturer.
Operate audio or video equipment while inside the spa
unless it is with the
remote approved or provided by the manufacturer. Do not connect auxiliary
components (i.e. headphones) to the system.
Place electrical appliances within five feet (1.5m) of the spa.
Use an extension cord to connect the spa to its power source.
The cord may
not be properly grounded and the connection is a shock hazard. An extension
cord may cause a voltage drop, which will cause overheating of the pump(s),
cause motor damage and will void the manufacturer’s warranty.
Attempt to open the spa control box
unless you are instructed to do so by a
representative from technical support. Without proper instruction, you should
not attempt to service the parts inside the spa control box.
IMPORTANT INFORMATION
ABOUT SPA SAFETY
6
Summary of Contents for Spa
Page 1: ...Owner s Manual...