Lagoon 421, Owner'S Manual, Page: 21 / 122

LAGOON 421
1
NAVIGATION
19
• MOORING WITH ELECTRIC WINDLASS
Activate the windlass with the control found in the windlass locker or
from the steering station.
If the port engine is not functioning,the windlass can work on service
batteries (if available) by switching on the port engine ignition only
(the engine alarm will then sound while the windlass is in use).
NOTE: The batteries can be recharged via the generator (optional
extra) if the engines do not start.
• HEAVING UP THE ANCHOR
- Lock the cable lifter snubber.
- Ensure the chain is properly set on the cable lifter.
- Slowly go near the anchor, using your engine (Don't use your win-
dlass to winch the boat).
- Release the bridle from the chain.
- Heave the anchor completely.
- Visually check the last meters till the anchor gets into contact with
the davit.
- Secure the anchor or anchor chain to the cleat.
In the case of electrical failure use the winch handle on the windlass
to lift anchor.
• MAINTENANCE
After each trip rinse the windlass and mooring line with fresh water.
Refer to the manufacturer's instructions for windlass maintenance
at the beginning or end of the season.
WARNING
Nobody should be aboard the tender during maneuvers car-
ried out with the davits.
WARNING
Windlass operations are dangerous:
- Always keep the anchor line unfouled and free.
- Always proceed with care, using gloves and always wea-
ring shoes.
NAVIGATION