Classic Collection Installation Instructions 4
BACK
Optional Extension Brackets
Extension brackets can be used on outside mounts to project the
installation brackets from 2 3/4” to 4 1/8” from the mounting surface.
This allows additional clearance of obstructions such as window
cranks or handles.
• The extension brackets may be fastened together two different
ways to produce the desired wall extension as shown.
• Attach the extension brackets using the nut and bolts sent.
• Mount the extension bracket assemblies to the window frame or
wall using two diagonally located screws.
• Use the appropriate fasteners to bolt the mounting brackets to the
extension brackets.
Wand TIlter
.006 gauge blind wands are provided with a clip on wand tilter
that simply “snaps” onto the wand tilter.
•
Grasp wand tip between forefinger and thumb.
• Rotate the tilter until the hole is horizontal with the slats and
push wand into hole on the tilter as shown.
.008 gauge blind wands are provided with a plastic sleeve and
metal hook.
• Remove the plastic sleeve by pulling upward. The hook on
the wand will be in an open position.
• Slide the plastic sleeve removed from the wand over the
metal shaft of the tilter until the hole is exposed.
• Holding the sleeve above the hole, pull the wand hook
through the shaft hole until it rests in the bend of the hook.
• Slide the plastic sleeve back down over the hook until it is
back in the closed position.
Nut & Bolts
Optional Hold-Down Brackets
Plastic Hold-Down Brackets
• Attach the hold-down brackets to the jamb, sill or outside
mounting surface. When the blind is fully lowered, the pin on
the hold-down must align with the center of the bottom rail
end caps.
• Insert the pin on the hold-down brackets into the end caps to
secure the bottom rail. A hole may need to be punched in the
end cap to accept the pin in the hold-down.
Metal Hold-Down Brackets
• Insert a hold-down pin into each of the bottom rail end caps.
• Attach the hold-down bracket to the jamb, sill or outside
mounting surface. When the blind is fully lowered, the hold in
the hold-down brackets must align with the pins in the bottom
rail end cap.
• Insert the pins into the holes in the hold down brackets.
