INSTALLATION
3
Installation Overview
To install your shade, you will need to perform the following three easy steps:
STEP 1:
Install the Brackets
STEP 2:
Install the Shade
STEP 3:
Connect the Power Source
STEP 1 — Install the Brackets
■
Your order will include the correct number of installation
brackets for your shade width, as shown in the table.
➤
There are two sizes of installation brackets, one for
3
/
8
" and
3
/
4
" pleat sizes and a larger one for 1
1
/
4
"
pleat sizes.
➤
For end mounts, only two brackets are used up to the
maximum of 72".
IMPORTANT:
A
1
/
2
" spacer block is required for shades
using the battery wand clip. The spacer block is pre-attached to
the back of the installation bracket.
■
Should the spacer block become detached, reattach it.
➤
Insert the legs of the installation bracket into the tabs
on the spacer block.
➤
Rotate the installation bracket back,
as shown.
1¼"
Installation
Bracket
3
∕
8
" and ¾"
Installation
Bracket
1¼"
End Mount
Brackets
3
∕
8
" and ¾"
End Mount
Brackets
Shade
Width
Brackets
Required
12" – 36"
2
36
1
/
8
" – 72"
3
72
1
/
8
" – 108"
4
108
1
/
8
" – 144"
5
144
1
/
8
" – 174"
6
Tab
Tab
