Helpline Number 0845 268 2000
FITTING THE BOOSTER SEAT 22 – 36KG
(APPROXIMATELY 4 YEARS TO 11 YEARS).
1
2
3
4
Place the booster seat on the vehicle’s seat ensuring it is pushed
firmly against the vehicle’s seat and backrest (1).
Place the child on the booster seat (2).
Fasten the seat belt, making sure that the lap belt webbing goes
under both armrests and the diagonal belt webbing goes over the
armrest near the buckle. Tighten the seat belt by pulling upwards on
the diagonal strap (3).
Check the seat belt to ensure there is no slack and the belt has not
become twisted or trapped (4).
Check that the cover is not impeding the movement or fit of the seat
belt in anyway.
To release the child, simply unfasten the seat belt in the
normal manner.
These instructions are important. Please read
carefully and retain for future reference.
Backrest cover removal: First release the
elastic strap at the bottom of the backrest
cover. Slide the cover off. The cover can now
be cleaned.
Headrest, booster seat cover removal:
Slide the cover off. The cover can now be
cleaned.
Washing the covers: The covers should be
hand washed using a mild soap and warm
water. Do not use chemicals and never
attempt to bleach or dye the webbing.
Allow to dry naturally.
IMPORTANT Note:
The seat restraint must not be used without
the cover.
The seat cover should only be replaced with
one recommended by the manufacturer,
because the cover constitutes an integral
part of the restraint's performance.
Do not use the car seat after an impact or
accident.
6. Do not allow the seat to come into contact
with corrosive chemicals etc.
Only suitable if the vehicle is fitted with
3-point static, 3-point retractor safety belts,
approved to UN/ECE Regulation no. 16 or
other equivalent standards.
EXTREME HAZARD
Do not use in passenger seats equipped with
air bags (SRS)
Please remove the car seat from the vehicle
when it is not used and keep out of reach of
your child.
Please always fasten the car seat when it is
inside the vehicle.
Please always read the manual before using it.
The manual is in the pocket located on the
back of the cover.
1. This is a “Universal” child restraint, it is approved
to ECE Regulation 44.04 for general use in
vehicles and will fit most, but not all vehicle
seats.
2. A correct fit is likely if the vehicle manufacturer
has declared in the vehicle handbook that the
vehicle is capable of accepting a “Universal”
child restraint of this group.
3. This child restraint has been declared
“Universal: under more stringent conditions
than those applied to earlier designs which do
not carry this notice.
4. If in any doubt, consult either the child restraint
manufacturer or the retailer.
5. Keep the seat covered when the weather is
hot as the buckle and other metal objects may
become hot.
