Lacunza Nickel AUSTRALIA, Instruction Book

Page: 8 / 29

INSTRUCTIONS FOR THE INSTALLER 7
2.
closable outside-air inlet with a section of
at least 90 cm².
2.2.2. Location of the appliance in the
room
Choose a location in the room which
favours good hot-air distribution by
convection and radiation.
WARNING!: The appliance must be
placed on a raised support or bench that
allows the passage of air for combustion
under of it.
Figure No.4 - Combustion air intake
Figure No.5 - The appliance musti be
placed on a bench.
2.3. Installation of the appliance
2.3.1. Floor
Make sure that the base can withstand
the total constructed weight of the
appliance and its casing.
The apparatus should not be placed on
combustible material.
Nickel 800
A minimum 520mm deep x 720mm
wide x 50mm thick floor protector (Skamol
board) should be used under the appliance
base when installing the appliance (see
joint AS/NZS 2918:2018 3.3.2). A minimum
450mm deep x 1110mm wide x 36mm
thick floor protector (compressed board)
should be used in front of each of the
appliance doors and be placed centrally in
the 1110mm width. The Thermal resistivity
of the 50mm skamol board floor protector
is 0.74m².K/W. The Thermal resistivity of
the floor protector is 0.16m².K/W for
36mm thick compressed board sheets.
Minimum air gap of 40mm must be
maintained under the appliance base to
the Skamol floor protector.
Nickel 1000
A minimum 510mm deep x 1015mm
wide x 50mm thick floor protector (Skamol
board) should be used under the appliance
base when installing the appliance (see
joint AS/NZS 2918:2018 3.3.2). A minimum
600mm deep x 1320mm wide x 36mm
thick floor protector (compressed board)
should be used in front of each of the
appliance doors and be placed centrally in
the 1320mm width. The Thermal resistivity
of the 50mm skamol board floor protector
is 0.74m².K/W. The Thermal resistivity of
the floor protector is 0.16m².K/W for
36mm thick compressed board sheets.
Minimum air gap of 50mm must be
maintained under the appliance base to
the Skamol floor protector.