LaCie Quick Install Guide
6
Figure 3 - Securing Brackets to Rack
3. Assemble the left and right chassis latches using the special chassis latch screws. Ensure the latch is orientated as shown
in Figure 2, with the spring arm located against its stop. On the right hand side this is at the top, on the left at the bottom.
4. Assemble the rack brackets to the rack posts as follows (see Figure 3):
a. Position the location pin at the rear of the rail into a rear rack post hole. Attach the bracket to the rear rack post using
the washers and screws supplied. The screws should be left loose.
b. Extend rail to fit between the front and rear rack posts.
c. Attach the bracket to the front rack post using the washers and screws supplied. The screws should be left loose.
d. Tighten the two clamping screws located along the inside of the rear section of the rack bracket (see Figure 3).
5. Mount the enclosure into the rack as follows (see Figure 4):
a. Lift the enclosure and align it with the rack rails.
b. Carefully insert the chassis slides into the rack rails and push fully home.
c. Tighten the rear rack bracket mounting screws.
d. Withdraw enclosure until it reaches the hard stops (approx. 400mm) and tighten the front rack bracket mounting
screws.