DSLR Out:
3.5mm stereo connector for transferring the exposure signal to
DSLR cameras.
Using Standalone mode:
Connect the DSLR In connector or the USB port to receive the shutter
signal from your DSLR control unit (Lacerta MGEN or a remote shutter
controller), and connect the DSLR out to transmit the same shutter signal
to your DSLR. Power up the FBC (the LEDs light up in a sequence) and
your DSLR in bulb mode. The 3 potentiometers on the unit are used to
set the desired values. Trigger an exposure on your DSLR control unit.
After receiving the incoming exposure signal, the shutter of your DSLR
opens and the Flatbox lights up according to these settings. When the
shutter signal ends, your DSLR shutter will close. The length of your
shutter signal, when programmed on the external device, should be
longer than the values of Delay + Flash.
Delay(ms):
Sets the delay time after the exposure signal has been
received, before the Flatfield device is started.
Flash(ms):
The illumination time of the flatfield device connected.