Installation Instructions/Instrucciones de Instalación
LACAVA LLC
4
1. Determine where the pedestal will be located. Note location of holes toward the
bottom of the pedestal.
2. Secure each mount to the floor at the location of the holes in the pedestal using the
included hardware.
3. Place pedestal over the mounts and use included hardware to fasten pedestal to
mounts.
MOUNTS
4. Run p-trap through cut-out in the pedestal and install to waste hole in wall.
5. Insert the bottom portion of the drain into the top of the p-trap.
6. Place top portion of drain with washer through the drain hole from inside the bowl of
the sink.
7. Set sink with drain on top of the pedestal.
8. Thread top portion of drain into bottom portion already installed in the p-trap. Tighten
until snug and a water tight seal is made with sink.
9. Run water down the drain while looking through cutout into pedestal (may have to use
mirror). Make sure there is no water leaking from drain or trap.
10. Install cover over pedestal cut-out (if floor plumbing used).
