Lacanche Vougeot - Volnay, General Manual

Page: 17 / 45

Page 17 of 45 – US –
ELECTRICAL
It is hazardous to put the appliance into
service without connecting it to suitable ground.
No liability can be accepted for accidents resulting
from non-compliance with this requirement or
incorrect grounding. Connect the equipotential
bonding terminal (
N , Figure 31).

Before connection, check that the :
Mains voltage is compatible with the appliance’s rated voltage and thermal output.

Connection:
- Use a 4-wire rated for 30 A 125 / 250 VAC, type SRD, SRDT, S, SO or ST.
- Where local Codes do not permit grounding through neutral, use a 4-wire power supply cord or “pigtail” kit.
Cord must be agency approved for use with household ranges.
- Remove access door O (Figure.32, gas oven range) or P (Figures 33 and 34, gas and electric range).
- Remove cable clamp and loosen supply cord mounting screws on the terminal block.
- Connect to terminal block in accordance with figure 36.
- Secure the cable by means of cable clamp, item Q (Figure 35).
- Refit access door
Fig. 33
P
Fig. 32
O

THE APPLIANCE WHEN INSTALLED, MUST BE
ELECTRICALLY GROUNDED IN ACCORDANCE
WITH THE LOCAL CODES OR The National Electrical
Code, ANSI/NFPA 70-1996 or latest edition.

ALL WORK ON OR REPAIR OF AN APPLIANCE
MUST BE CARRIED OUT BY A QUALIFIED
INSTALLER.
IMPORTANT
N
Fig. 31