Safety
33
Lockout/Tagout Procedure
The lockout/tagout procedure should be followed whenever you are inspecting, cleaning or repairing
your W
ITTKE
R
ETRO
F
L
TM
.
Figure 2-2 Lockout/tagout tags
N
OTE
:
Failure to follow the lockout/tagout procedure may result in serious injury or death. Prior to
performing under body work it is necessary to set the body prop as explained later in this
manual.
The following is the lockout/tagout procedure:
1.
Set the chassis parking brake.
2.
Turn off the hydraulic pump.
3.
Activate one of the hydraulic controls to relieve any residual pressure in the system.
4.
Turn off engine, remove keys from the ignition and store the keys in a safe, controlled area. It is
recommended that you keep the keys on your person.
Top Door Not Open
Yes
Tailgate Ajar
Yes
Tailgate Fully Open
Yes
Yes
Body Raised
Yes
Yes
Table 3
Warning lamps (Cont’d)
Action
Amber
Caution
Red Danger
Red
Overheight
Green
Autopack
Red Pump On
Summary of Contents for Pendpac WITTKE RETRO FL
