Labrie automizer, Maintenance Manual

Page: 36 / 243

26 General Maintenance
3 c.
Grab the panel handle and pull the panel towards you.
Figure 3-5 Floating panel
4.
With a scraper or pressurised water, remove all accumulated dirt behind the packer, under the
cylinder brackets, and inside side rails (see Figure 3-7).
5.
Remove debris through the clean-out traps (see Figure 3-6).
Figure 3-6 Removing debris through the clean-out trap
6.
Finish cleaning the area with pressurized water.
7.
Once cleaning is complete, close the floating panel. To do so:
7 a.
Push on the floating panel to close it.
Caution! When opening or closing the floating panel, keep hands and fingers away from the pinch
point area.
Spring-loaded
latch
Panel handle
Floating panel