Labrie automizer, Maintenance Manual

Page: 113 / 243

Lubrication 103
5.
Once the sample is taken, remove the probe from the coupler and pull out the probe to remove it
from the bottle (see Figure 4-7).
Figure 4-7 Pulling out probe from bottle
6.
Put the seal cover over the bottle cap.
Figure 4-8 Sealing bottle
7.
Fill in the identification form (sticker) and apply it on the sample bottle (see Figure 4-9).
Figure 4-9 Identification form (sticker)
Lubrication charts in this manual may differ from the ones displayed on the vehicles. For lubrication
specifications, always refer to the charts on the vehicles.
Sealed sample